Free Shipping

10A Relay 12V 4CH Channel 433MHZ Wireless Remote Control Switch Receiver Board with Remote


To confirm that this part fits your vehicle, please enter your vehicle's details below.

  • Year:


    • Make:


      • Model:


        • Submodel:


          • Trim:


            • Engine:


              • Clear All
              This part is compatible with 0 vehicle(s).
              Show all compatible vehicles
              This part is compatible with 1 vehicle(s) matching
              This part is not compatible with
              Recent searches

                • Year
                • Make
                • Model
                • Submodel
                • Trim
                • Engine

                  Input Voltage: DC10-14V
                  Standby Current: <5MA
                  RF Frequency: 433MHZ
                  RF Working mode: Super heterodyne receiver
                  Receiver Sensitivity:  >98dBm
                  Remote Control Distance:  >100 meter(In open environment)
                  Decoding Way: MCU Software decoding
                  Can store the number of remote control: 50
                  Support remote control type: Fixed code, learning code
                  Channel: 4CH
                  Multiple working modes: (Jog/Non-Latched ,inter-lock/Latched ,self-lock /Self-Latched,Delay off)
                  Wiring Method: Fixed wiring terminal
                  Working Voltage: DC12V
                  Output Current: 10A
                  Output: Normally open,Common,Normally closed
                  Size: 50x70x25mm
                  How to use:
                  1. Jog/Non-Latched: Press one button is Working /ON. Loosen your finger on the same button is Stop/OFF. One channel switch need one buttons remote control.
                  2. Self -lock/Self-Latched: Press one button for one time is working/ON. Press the same button again is stop/OFF. One channel switch need one buttons remote control.
                  3. Inter-lock /Latched: Press one button is working/ON, press another button is stop/OFF. One channel switch need 2 buttons remote control.
                  4. Delay: Press remote control 's one button,relay is working,release the remote control and begin timekeeping,after 5s/10s/15s will automatically close the relay
                  1. Press the learning code .the indicator flash ,loosen your finger ,press any button of the remote control (press 1 times to learn Momentary; 2times-Toggle;3times-Latched;4times-5s delay;5times-10s delay;6times-15s delay)
                  the indicator flash 2 times and off .it mean you learn it successfully .
                  2. It can learn 2272 2262 or 1527 chip with the different code wireless 315MHz remote control
                  Press the learning button about 8 seconds , the indicator turn on to off, it means the information that you keep have been removed successfully .
                  Package Included:
                  1 x 12V Wireless Relay Switch
                  1 x Remote

                  Leave a Comment